Flow rate solenoid controlled valve figure XLC 335/435 PN 25

The CSA XLC Model 335/435 limits the flow to a pre-set value, regardless of pressure variations. In case of flow rate lower than the required set point the valve will be fully opened. The valve is supplied with an orifice plate assembly, needed for the proper functioning and connected to the pilot. Thanks to a solenoid and an hydraulic accelerator the valve will open/closed in response to signals.

Product features

• Body and cover in ductile cast iron GJS 450-10.

• Internals in ductile cast iron GJS 450-10 and stainless steel.

• Position indicator in stainless steel.

• Circuitry in stainless steel.

• Unit flow regulator device, needle valves and flow stabilizers in stainless steel.

• Seat in stainless steel.

• Painting with fluidized bed technology RAL 5005.

Applications

• Flow rate control of a tank feeding line tank with the possibility of interrupting the supply in case of alarm and emergency situations.

• Pumps protection against excessive flow conditions with the valves’ full opening or closing in response to signals.

• Avoiding excessive flow if installed on gravity lines right downstream of storage tanks, with the interruption of supply through signal to the solenoid if the valve’s circuit in case of pipe burst.

Standard and connections

• Design and testing according to EN 1074.

• Flanges size from DN 50 to DN 800 mm (XLC 400 series) and up to DN 1000 mm (XLC 300 series), higher on request.

• Flanges standard EN 1092/2, different on request.

Working conditions

• Pressure range: 10-16-25 bar.

• Minimum working pressure: 1.2 bar acting on the pilot.

• Treated water maximum 70°C, higher temperature on request.